The D1M-1B2006 is a 64-termination rear cross-connect panel with bantam jacks and 120 Ohm resistor. The panel includes two 4-inch x 4-inch (10.2 cm x 10.2 cm) jumper rings, horizontal cable tray, orange LEDs, and designation labels numbered 1-64. The panel can be mounted flush or with a 4- or 5-inch recess in a 23-inch (58.4 cm) rack. The 64-termination panel is primarily deployed with equipment configured in multiples of 32 such as digital cross-connect systems and some digital switches. ***Photo shown represents typical product likeness, but may differ from actual product catalog number listed here. Check specific product drawing for actual product detail. *** Some key features and benefits of the D1M-1B2006 are: Die-cast Bantam jacks are rigorously tested with over 10,000 insertions/withdrawals Superior cable management designed into each panel LEDs flash at both ends of the monitored circuit for 30 seconds Cross-connections are located on the rear of the panel Guarantees reliability, durability, and quality over time Simplifies cable routing and circuit identification for growing and changing networks Quick identification of cross-connected circuits Maximum panel circuit density in a rear cross-connect style